Bompani BODPxxx User Manual download pdf (Page 4)

4 524

I

GB

Identificazione dell’apparecchio.

Su ogni apparecchio e applicata una targhetta segnaletica posta all’interno del frigori-

fero sulla fiancata adiacente al cassetto frutta e verdura. (Fig. 1)

CARATTERISTICHE

La principale caratteristica e:

- Sbrinamento automatico della cella frigo. L’acqua di sbrinamento viene convogliata in

una bacinella posta sul compressore da dove evapora con il calore generato durante

il processo di refrigerazione.

ISTRUZIONI PER L’USO

fig. 1

IDENTIFICATION OF THE APPLIANCE

You will find an identification label inside the refrigerator nearby the fruit and vegetable compartment (fig. 1)

CHARACTERISTICS

The main characteristic of the refrigerator

- Automatic fridge defrost. The de frost water flows into a tray situated on the compressor

from which it evaporates by the heat generated during the process of refrigeration.

INSTRUCTIONS FOR USE

ATTENZIONE!

Quando installate il vostro apparecchio frigorifero è importante tener

conto della classe climatica del prodotto. Per conoscere la classe clima-

tica del vostro apparecchio controllate la targa dati qui riportata.

L’apparecchio funziona correttamente nel campo di temperatura am-

biente indicato in tabella, secondo la classe climatica.

WARNING!

When you install your refrigerator, it is important to bear in mind the climatic

rating of the appliance. In order to find out the climatic rating of your appliance,

check the data rating plate. The appliance will function correctly within the am-

bient temperature range indicated in the table, according to its climatic rating

Mod. 1Mod. 2

Green and Yellow

to Earth

Blue to

Neutral

13 amp

Fuse

Brown

to Live

Cord

Clamp

COLLEGAMENTO ELETTRICO

Controllare che la tensione dell’impianto elettrico corrisponda a quella indicata sulla

targhetta caratteristiche posta sul lato sinistro in basso nella parte interna dello scom-

parto frigorifero.

Se la presa a muro è priva di contatto a terra, o se la spina non è adatta al vostro

impianto vi consigliamo di rivolgervi ad un elettricista specializzato.

Non impiegare adattatori o derivatori che potrebbero causare riscaldamenti e bru-

ciature.

Qualora l'apparecchio non sia provvisto di spina, l'allacciamento alla rete elettricadeve

essere realizzato installando un interruttore direttamente connesso ai morsetti di ali-

mentazione. Tale interruttore deve garantire una disconnessione onnipolare dell'ap-

parecchio con separazione dei contatti di almeno 3 mm

ELECTRICAL CONNECTION

Check that the main voltage corresponds to that indicated on the rating plate in the lower left

side inside the refrigerator compartment. If the wall socket does not have an earth terminal,

or if the plug does not fit into the socket, it is advisable to consult a qualified electrician. Do

not use multiple plugs or adapters as they could cause heating and burning.

Warning: this appliance must be earthed

If this appliance is fitted with a non rewirable plug for which your socket is unsuitable, the

plug should be cut off and an appropriate plug fitted. The removed plug must be disposed

of Insertion of the plug into a 13 Amp socket is likely to cause an electrical hazard When

a nonrewirable plug ora rewirable 13 Amp (BS1363) plug is used it must be fitted with a

13 Amp ASTA approved (BS1362) fuse. If any other type of plug is used it must be pro-

tected by a 15 Amp fuse either in the plug or at the distribution board

Important: The wires in the main leads are coloured in accordance with the

following code: GREEN AND YELLOW - EARTH BLUE - NEUTRAL BROWN - LIVE

As the colours of the wires in the main lead of your appliance may not correspond with the

coloured marking identifying the terminals in your plug, proceed as follows. CONNECT

GREEN & YELLOW coloured wire to plug terminal marked letter “E” or earth symbol

or coloured green or green & yellow. CONNECT BLUE coloured wire to plug terminal

marked letter “N” or coloured black. CONNECT BROWN coloured wire to plug terminal

marked letter “L“ or coloured red. If the appliance is not fitted with a plug, the connection

to the mains power supply must be via a switch connected directly to the power supply

terminals. This switch must guarantee single-pole disconnection of the appliance with a

contact gap of at least 3 mm.

1 2 3 4 5 6 7 8 9 ... 27 28

Comments to this Manuals

No comments